Uzi ( heebrea keeles עוזי, ametlikult suurte tähtedega UZI) on Iisraeli püstolkuulipildujate seeria. Do you still have questions? Leave them in the comment section and we will try our best to answer all of them.Lyttleton Engineering Works (Vektor Armsi all)
It is no big deal to have more than the enforced six-it gives you room to switch back to two imported parts later.įor a full description on how to install the fire control group, stock set, muzzle device, as well as giving your AK-47’s stock a refinishing, read the original article. With this set-up, we have actually installed eight U.S.-made parts on your post-ban AK-47. A U.S.-made gas piston, a muzzle device, magazine follower and magazine floor plate are all easy to replace parts. You may not have more than 10 imported parts on the post-ban AK-47. Remember, if you add or leave one imported part on the rifle, you must replace an imported part with a U.S.-made part elsewhere. If you go with a side folder or imported East German crutch stock, you will still need to replace another part. However, if you chose a fixed or collapsible wood or synthetic buttstock only, you will still need to replace two more parts to be compliant with the law. A stock set including the buttstock, pistol grip and handguard count as three more parts. One of the main parts of your post-ban AK you are itching to change is that fixed thumbhole stock.
It might just mean you need to open up the area around the trigger slot in the receiver with a small file. Really made for milled receivers, with a little fitting you can get these double-hook fire control groups to work in a stamped receiver. The double-hook sets give you a more positive grip on the hammer and a smoother trigger let-off. This counts as three parts-only three more to go! You have two choices-a single– or double-hook fire control group. The fire control group consists of a hammer, trigger and disconnect0r. To cut your conversion costs down, you will want to select the smaller, less expensive parts.
If you have an imported “sporting” AK, especially if it is an Egyptian Maadi, Bulgarian or a Yugo M-90, it will be worth the extra investment in the end. However, since Obama’s sanctions against Kalashnikov Concern, pre-ban AK-47s are selling for a premium. This conversion might cost quite a few hundred dollars and a considerable amount of time.
To find out whether your AK is milled or stamped, read “ AK-47 Receiver Identification: Milled vs. For a milled receiver, you may replace only five parts. Meaning, you must have at least six parts made in the United States for your AK-47 to be legal and 922 (r) exempt.
To convert your post-ban AK-47 into one that looks pre-ban, you may choose only a maximum of 10 imported parts.